Concrete hardener
This coating mixture has significant adhesion to the underlying concrete and increases the durability and reliability of the concrete surface by reducing permeability.
Product code: STAR TOP H300
: Concrete hardener is a typical prepared cement powder composition with soft constituents, which is used as a dry spray on recently-poured concretes. After the operation, the dry-sprayed sections are completely smooth and integrated and become resistant to wear. The concrete surface hardener is produced for use in various industries, including: petrochemical, steel-making, parking lots, large stores, open surfaces, warehouses and production halls, as well as all surfaces that are exposed to abrasion, impact, and compressive tension. This product is produced in different colors.
• Obtaining a smooth and integrated finished surface
• Creating an impermeable and non-slip surface
• Reinforcement of concrete strength against erosion, wear, and impact
• Resistant to melting and freezing cycles
• Resistant to the penetration of harmful agents and chemicals
• Increasing the concrete durability
• Ease and speed of implementation
• The possibility to be combined with concrete colors
• Suitable for internal and external surfaces of the structure
• Adhesion capability and high adhesion to underlying concrete
• Capability to be washed and cleaned easily
• Leveling and strengthening of concrete floor-makers
• Flooring of workshops, factories, and warehouses
• Flooring of parking lots, garages, and loading areas
• Airplane hangars
• Flooring of carwashes and trade environments
Amount and method of consumption
The work surface must be clean, firm and free of any grease. dust, paint, oil and loose particles Depending on the performance required and the thickness of the execution, offer About 5.3 to 4 liters of water can be added to each 20 kg bag Add. Mixing the powder with water should be done using a mixer Electric (drill+blade) can be done. A bucket or a container that powder and The water mixed in it should be proportional to the speed of work be the mixing volume. Always add the powder slowly to the water and pay attention to the time of adding the powder to Water, the electric mixer should be turned on and the mixing process until achieved A uniform and homogeneous mixture will continue
Be sure to moisten the work surface before applying the prepared mortar with a trowel or spatula on the surfaces Apply moistened depending on the amount of porosity
Roughness of the applied surfaces, to cover one square meter 1 mm thick, about 2 kg
needed
Attention: Always mix some of the powder with water, which is maximum To be used in less than 20 minutes To obtain the desired resistance, after semi-drying The executed mortar, all surfaces for at least 7 days regularly by spraying water or using a wet sack, Keep moist
- Physical state: powder
- Color: gray, green, brown, yellow, orange, blue, and red
- Chlorine ion: N/A.
- Storage duration: one year in original packaging
- Storage conditions: away from moisture, humidity, and direct sunlight
- The best storage temperature: +10 to +30 degrees Centigrade
- Type of packaging: 25-kg buckets
This substance is not considered to be dangerous and harmful for health and the environment, however, it should not be swallowed or come into contact with the eyes. In case of accidental contact with skin or eyes, it should be washed immediately with plenty of fresh water. Visit a doctor immediately if swallowed. Avoid inducing the victim to vomit. This substance is not flammable.
